For interior jobs you can
use same as above or the following can be used for spans
up to 42" to 48" wide. Stringers still need to
be 2x6's. Interior risers can be 2x8's or 3/4"to 1 1/8 " plywood.
Interior treads can be 2x12's or 1 1/8" to 3/4" plywood
with EZ Stairs, stairs can be 'pre-built' or built 'in-place'.
Tools/Materials needed will
be: a power drill, saw (skill saw is preferable, but not
required,#8 1 1/4" Phillips flat head or star/square
drive screws for the stair brackets, #8 2 1/2" deck
screws for every 9" of tread and riser connection and
EZ Stair Spacers for customized riser and tread measurements.
Watch
3D animation first
Set-up (1) stringer at a
time by placing 2x6's parallel on a flat surface...start
6" from end by placing EZ Stairs spacer, then bracket
and spacer.....down the line. When you have all your spacers
and brackets lined up and tight insert 2 pivot screws in
each bracket... without tightening the pivot screws. Remove
spacers and pivot your brackets to your exact riser and tread
combination. Insert remaining screws in all the brackets
except the first and last step... these brackets will need
to be quickly pivoted out of the way to make the required
minimal end cuts. Repeat the process on stringer #2 and install
all risers and treads.
* Interior or exterior stairs
can be framed out and installed in most cases 2-3 hours or
less!
* Minimal skill is required and due to the fact that with
EZ Stairs saw-cuts are drastically reduced.....material is
seldom wasted!
* Spacers are adjustable to allow for customized rise and
tread configurations. Spacers are factory set at 'G'... accomplishes
most tread and rise requirements.
Building superior quality
interior or exterior stairs with EZ Stairs*All EZ Stair
bracket packs come with a complete 'step by step' DVD walkthrough
along with English/Spanish instructions*
